Idle Rod Length

johnbirchjar
moderator
Posts: 1061
Joined: Sat Mar 07, 2009 11:20 pm

Idle Rod Length

Postby johnbirchjar » Sun Jan 07, 2018 1:40 pm

Hi Guys,I trust you all had a good Christmas?and let me welcome you to the New Year with the need for a bit of info: wink
Can anyone tell me if the Idle Rod on Commander's is any longer than the one on the Classic/IP2's?('cos if not I have wee problem insomuch as mine is running out of thread before the Throttle Butterflies move evil)unless there is further adjustment somewhere else?J.B.

Anthony Duffield
moderator
Posts: 103
Joined: Sun Aug 11, 2013 8:13 am

Re: Idle Rod Length

Postby Anthony Duffield » Sun Jan 07, 2018 6:17 pm

John,

The idle rod length on my Commander is 20.5cm

Tony

johnbirchjar
moderator
Posts: 1061
Joined: Sat Mar 07, 2009 11:20 pm

Re: Idle Rod Length

Postby johnbirchjar » Mon Jan 08, 2018 12:08 am

Hi Tony,is this fully extended?J.B.

Anthony Duffield
moderator
Posts: 103
Joined: Sun Aug 11, 2013 8:13 am

Re: Idle Rod Length

Postby Anthony Duffield » Mon Jan 08, 2018 9:54 am

John,

20.5 cm is the set length, there is still a good bit of adjustment left but not required on my bike.

As long as the choke lever at the throttle butterfly's is properly aligned and you have the rod in the correct hole in the plate at the carb end 20.5 cm should be close enough

Tony

johnbirchjar
moderator
Posts: 1061
Joined: Sat Mar 07, 2009 11:20 pm

Re: Idle Rod Length

Postby johnbirchjar » Tue Jan 09, 2018 4:18 pm

Hi Tony,Yours is definitely longer wink,I measured the one off my Classic and it comes out at 19.00 at maximum extension(no wonder I am having prob's setting the Carbs up)The wheels are in motion for me to(hopefully) obtain a Commander one.
Thank you for your input,ride safe,J.B.

wust588
moderator
Posts: 82
Joined: Wed Aug 06, 2008 4:56 pm

Re: Idle Rod Length

Postby wust588 » Tue Jan 16, 2018 12:51 pm

Looking at the parts lists, the Commander and Classic have different part numbers.

These fast idle rod assemblies were made up in batches, but I can't remember whether the individual components are of different lengths.
The assemblies were "set" to length by loctititing the threaded short rod into the brass sleeve.

You might find that if you heat up the brass sleeve and break the loctite you can extend the length of the assembly. On the ones I have, the short
piece is screwed into the sleeve about 10mm.

Hope this makes sense.

johnbirchjar
moderator
Posts: 1061
Joined: Sat Mar 07, 2009 11:20 pm

Re: Idle Rod Length

Postby johnbirchjar » Thu Jan 18, 2018 11:56 pm

Thanks for the info,but I have now had a "longer "one made cool (and will keep the Classic one for when the Classic engine once more returns to the frame wink)ride safe,J.B.


Return to “technical interest and new ideas”

Who is online

Users browsing this forum: No registered users and 2 guests